Barrel Threading

At VCG we can thread the barrel of many different types of firearms, all barrel threading is done centered off of the bore, not the outside of the barrel, all threading is lathe, single point thread cut. If your barrel is less than 21 inches in length, we will have to remove it from the receiver to thread it.

Prices vary depending on the complexity of the job. A couple examples, (1) an unmounted rifle barrel 9" - 30" long, (2) a remington 700 barreled action with a 22' barrel, cost would be the same for both at 150.00.

Another example, other end of the spectrum, an ak-47 with a 16 inch barrel, wanting the barrel shortened to 14.5", threaded, and pin / weld the muzzle brake in place. Job goes like this, remove front sight base, remove gas block, remove rear sight block, remove barrel from receiver, cut, crown, and thread muzzle, contour barrel to accept front sight base. Then press on rear sight base, gas block, front sight base, press barrel back into receiver, install pins in reciever, rear sight base, gas block, cut new pin seat in barrel for front sight base, install pin. Then install muzzle brake, pin and weld. Cost for this job would be 400.00

Simple barrel threading jobs include, any unmounted rifle barrel, AR-15 / AR-10, Ruger 10-22, Savage models with barrel nut, most rifles with barrels longer than 21" etc. cost 150.00

When in doubt it is better to send an e-mail, with details, for a quote.

This service is provided ONLY to customers who purchase our muzzle brakes.